elevator car

英 [ˈelɪveɪtə(r) kɑː(r)]

美 [ˈelɪveɪtər kɑːr]

网络  电梯轿厢; 轿厢; 电梯车厢

英英释义

noun

• where passengers ride up and down
  1. the car was on the top floor
  Synonym:car

双语例句

• Design of an elevator car controller based on CAN Bus
  基于CAN总线的电梯轿厢控制器设计
• A diagram showing the location of your elevators, car numbers and the elevator car phone number should be in your designated security area.
  在指定的安全区域，应有一张体现电梯位置，电梯厢号以及电梯里电话号码的图表。
• Under four extreme working conditions, the dynamic response of elevator car and the natural frequencies of the instantaneous systems are calculated.
  对于电梯运行的各种工况下，文章对振动的响应都作了分析与计算，并对瞬时系统固有频率也作了计算分析。
• In this thesis, elevator car space occupancy recognition system was studied. People or things in the elevator car can be detected automatically through image processing algorithms implanted into embedded systems when the car internal image was obtained, thus the occupancy percentage of car can be identified.
  本论文对电梯轿厢空间占用识别系统进行了研究，将图像处理算法植入嵌入式系统，通过采集轿厢内部图像，自动检测出轿厢中的人或物，进而识别出轿厢空间占用率。
• The light turns on as soon as the elevator car is activated, such as when the elevator doors open.
  电梯启动像电梯开门这种情况下，灯会立即开启。
• Vibration acceleration response of the elevator car is used as feedback signal and thus the engineering implementation of the active control will be simplified.
  采用电梯矫厢的振动加速度作为反馈信号，将使主动控制在工程上易于实现。
• ⑵ Through MATLAB software on traction elevators were 12 degrees of freedom vibration model and the horizontal direction perpendicular to 8 degrees of freedom vibration model simulation, respectively, high-speed elevator car by the maximum peak to peak vertical vibration and horizontal vibration of the dynamic model curve.
  ⑵利用MATLAB软件分别对曳引电梯的12自由度垂直振动模型和水平方向8自由度振动模型进行仿真，分别得到高速电梯轿厢垂直振动的最大峰峰值与水平振动的动力学模型曲线。
• PID control means is usually used in the current leveling precision control of the elevator car. It is difficult to meet the requirements for usage performance of elevator at high speed lifting.
  在现有的电梯轿厢平层精度控制中，大都采用PID控制方式，难以满足高速电梯的使用性能要求。
• It analyzes a hydraulic elevator car frame used in the museum, sets up its multi-loops structure and variable working conditions load.
  某博物馆液压电梯轿厢架具有多重框架的结构特点和变工况的载荷特征，传统公式计算法难于进行应力和变形分析。
• In the present study, a two-dimensional model of the elevator car and counter weight system was set up;
  此外，本文还建立了全三维的电梯轿厢-对重模型，定量分析了气动力的大小。